Final step is to do the brackets around the tower and mansard roof and the decorative roof brackets.
The instructions call this “exterior trim.” I say, “a ton o’ brackets.”
First, the brackets that go around the bottom of the tower and mansard roof.
These are sandwiched, large between two small. You need four complete brackets for each side of the tower, four on the front wall right and five on the right wall. That’s 25 total, and that’s just this half of the house … (you need 12 for the other half if you’re building the whole thing like a normal person). That’s a lotta brackets.
Ready for more sanding and painting.
You end up with a bunch of these.
Glue them bird-head up around the base of the tower, all four sides.
Back of the tower.
This is the right side walls–four in front, five in back.
Note that the end brackets on each wall are right at the edge, over the vertical trim. I glued those brackets on first, then spaced the others according to those.
The tower brackets were spaced about 2.5 inches from one another, the front wall 2 inches, the side wall 2.5 inches.
Last are the pointy and curly brackets that go around the edges of the roofs. Four complete ones on the tower, three on the porch, two on the right side (and three on the left). The look like this on the sheets.
We have standalone posts, posts with curls, and curls alone. Again, you glue these brackets together in sandwiches.
You make a sandwich of two standalone posts around one post with curly. The unattached curl gets glued to the post depending on which direction you need to go on the roof. Those are glued on as you place them on the rooftops.
When they’re glued in place, they’ll look like this.
Don’t glue the last curly part in place! I’m holding it here as a demo.
Starting with the porch: The posts are all glued with the flat side of the post facing front (*except* the one on the back of the porch which faces the side–got it?)
Here are the post sandwiches glued in place.
The lone curly is then glued to the other side. For the porch post in the back, it’s done. It doesn’t get a second curly.
The porch roof done. Note that the brackets are on the *inner* edge of the roof trim.
On the tower–the four post sandwiches in place. Again, the flat side of the picket faces front (and rear), and they’re glued on the inner edge of the trim.
The curlys all glued in place to complete the brackets.
Brackets done on the side roof.
And … that’s it!! That is the last bit of the kit for the right side of the house.
I still have to finish the wall I knocked out, do a lot of touch-up paint, and trim more raw edges. Plus I did not use the foundation trim–I will be putting stone or brick paper around the bottom.
But hey, there we have it! Almost ready to move in!